Forum General Discussion Forum :
Discuss bands, songs, music genres... 
The cause of the failure of the submersible pump not pumping water
Posted by: qianyuqianxun ()
Date: May 13, 2019 10:54PM

     The submersible pump's seal is too tight for the packing, the cooling water cannot enter the packing, or the shaft surface is damaged. Some measures can be taken, such as properly relaxing the packing and cleaning the sealing tube. Packing wear must be replaced. Pre-installed in the place where the oil is immersed, and then turn into the incision to be staggered to reduce water leakage.

1. Submersible pump vibrates

     It may be that the electric rotor is unbalanced, or the coupling is not well combined, the bearing is worn and bent, or the rotating parts are loose and broken, or the pipe bracket is not firm, etc., which can be individually adjusted, repaired, reinforced, and replaced.
read more:

Horizontal Split Case Double Suction Water Pump
Prestressed electric Water Ring Vacuum pumps
New type design vacuum rapid tempering furnace with gas cooling
China High Performance Supplier 5Pa Air Conditioner Drain Pump

Options: ReplyQuote

Sorry, only registered users may post in this forum.